Ferial Hakami & Alokesh Pramanik 
Tribology of Elastomers 

This book highlights the tribological behavior of elastomers by investigating the effect of operating variables such as, the applied load and the abrasive particle size, and the materials’ mechanical properties such as, tensile strength, elongation at break, hardness, and tear strength by the experimental, statistical and analytical methods. It is found that the wear mechanism is mostly friction wear, which is mixed with fatigue wear and abrading under higher applied loads or larger abrasives. The statistical method shows that the abrasive particle size has the highest contribution followed by the applied load on the wear process. Wear equation is developed to predict the wear rate considering the trends of the input variables.

Table of Content

1. Introduction.- 2. General background.- 3. 
Wear of rubber material in conveyer belt system.- 4.  Materials and Methodology.- 5. Effect of the applied load.

About the author

Dr Ferial Hakami graduated in 2007 with a BSc in Materials Engineering degree from Amir Kabir University of Technology, Tehran, Iran. She then completed her  MS (2010) in Metallurgy & Materials Engineering from University of Tehran, Tehran, Iran. She obtained her Ph D on the Tribology of Elastomers from Curtin University, Perth, Australia in 2018. Currently, she is working as a visiting scholar at the Department of Mechanical Engineering, Curtin University.  Her research interests are in the areas of tribology, manufacturing processes, material behavior and material treatment.




Dr Alokesh Pramanik is currently a lecturer in the Mechanical Engineering Discipline, School of Civil and Mechanical Engineering at Curtin University. He completed his Masters and Ph D degrees in Mechanical Engineering from National University of Singapore and University of Sydney respectively. Dr Pramanik has more than 15 year of research experience in the fields of manufacturing as well as composite materials at different universities. 





Dr Animesh Kumar Basak graduated in 2002 with a BSc in Metallurgical Engineering from Bangladesh University of Engineering and Technology (BUET), Dhaka, Bangladesh with honours. Upon completion of his Masters and Ph D degree in Materials Science and Engineering from Katholieke Universeteit Leuven (KULeuven), Belgium, he started working in different Australian universities. His research interests include nanostructured materials, high resolution electron microscopy and probe analysis, nanoscale fabrication of materials, deformation mechanisms of novel materials, nanomechanics, tribology and tribocorrosion, electrochemistry and electrochemical measurement techniques. He has published more than 50 research articles which are well cited in this area.